answersLogoWhite

0


Best Answer

On the older 4.0L Ford there is a plastic shroud directly under the radiator. Remove it (not hard) and you should find the drain petcock. It is easy to spot and is on the passenger side of the radiator.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 2000 Ford Ranger V6 3.0 Where is the drain plug for the water jacket?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil drain plug on a 2000 Ford Ranger 2.5 4 cylinder?

The oil drain plug on the 2000 Ford Ranger is on the rear of the oil pan. It is located under the vehicle near the center.


Were is drain plug automatic transmission 2000 ford ranger?

underneath the engine


Block coolant drain plug 2000 ford ranger 3.0?

lorftion drain plags 3.0 l Ford


Where is the oil drain plug on a 2000 Ford Ranger V6 4.0?

On the oil pan, bottom of engine.


How many wires on a water temperature sensor for a 2000 ford ranger 4.0?

There are either two or three wires on a water temperature sensor for a 2000 Ford Ranger 4.0.


Can you use a transmission from a 1993 Ford Ranger to a 2000 ranger?

can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?


Where is the coolant temperature sensor for 2000 Ford Expedition 5.4 L 4x4?

it is behind the thermostat in the water jacket


Where is the AC water drain on a 2000 Chrysler Sebring convertible?

It is on the lower passenger side of the firewall.


Does the 2000 Chevy Malibu have a freeze plug?

Let's drain the coolant, fill it with water, and find out!


Where is the fusible link on a 2000 Ford Ranger?

where are the fuseible links located on a 2000 ford ranger


What are the bolt patterns for a 2000 Ford Ranger?

bolt pattern for 2000 ford ranger & ft pounds


Step by step: How do you flush the radiator of a 2000 ford ranger your truck has an underbody shield and you can't locate the drain plug?

The radiator drain is located under the radiator (you may have to raise your vehicle to spot it beyond the shield). (1)Remove radiator cap and attach a 3/8" diameter hose to the drain fitting to direct the coolant into a container and then open the drain fitting with a pair of pliers. (2)Flush radiator with fresh water from a garden hose until water runs clear through the plug. (3)Refill with 50/50 mixture of water and antifreeze. Piece of cake, huh!! The hardest part is locating the drain fitting which appears to be well hidden, but I think it is on the driver's side of the radiator. Good luck. By the way, intructions are from Haynes Repair Manual Ford Ranger 1993 - 2005.