Check the fuse first, then the brake bulbs. When you press the brake, it senses the brake lights and let's you take it out of park. This happened to me - 2 brake lights burnt at the same time with one already gone, and I couldn't get it in gear. I replaced the bulbs, touched the brake pedal and she went into gear no problem.
yes there are fog lights installed on the touring model... i think this is a factory option Here are the instructions for installing the fog lights; http://www.handaaccessories.com/odyssey/05odyfoglight.pdf
Are you sure you need the fuse for the cruise control. My cruise control wasn't working, neither were my brake lights. All 7 bulbs were burnt out. When the brake lights were replaced the cruise control worked.
I had this same problem with my 2003 Venture. The Cheverolet dealership told me that the cruise contol is directly linked to the brake lights. The simplest and cheapest place to start would be to check your brake lights...if they are not working, you will not have cruise control.
The cruise control may not work is there is a problem with the brakes. Check to ensure that the cruise lights come on in the dash. Also, check all the vacuum lines to see if there is any issue.
Are your break lights working? Not sure, but some times mfr's disable cruise when brake light(s)is out. Otherwise try fuse.
Check that the cruise control module fuses are not blown in the fuse panel. Also make sure your stop lights are working; cruise controls are designed to disengage when the brakes are applied, and one method of sensing that is to monitor brake light current.
I figured my own question out....all it was, was the fuse.
answer: replace the headlights switch.
signal lights not working.
It shouldnt. The cruise control senses by the switch on the pedal not by the lights.
if it is a standard transmission, check the clutch switch on the pedal, may fix the problem. it did on my accord. i own a calais w/o cruise. hope you find the problem.
Common issue...if the brake light swith is not working; the cruise control will not engage and your brake lights will not go on. replacing switch is easy and inexpensive...its located in the upper part of the brake pedal.