Before taking the dash apart check the resistor. I have a 97 Dakota & it is located under the cowl. That resistor controls the fan speeds. You can check the switch using the resistor connecter. Pull connecter off resistor & use a 12 volt test light. Turn ign on & check for voltage at connecter on each fan speed. Have voltage then it is the resister or fan. (you can run a jumper wire from battery to fan to check it) No voltage then you go to the switch/wires etc. 95% of time it is the resistor.
My 2001 Dodge Dakota R/T 's blower fan for the a/c unit quit working in mid use. I checked all fuses, and relays, with no success. Does anyone know how to remove the fan switch, and test it?
You remove the compressor and replace the belt with one for a truck with out ac
No you don't have to remove the air conditioner dryer to use the pulley.........
relays behind fuse box, remove lower dash panel under steering wheel,relays listed on cover..
Remove the drive belt from the air conditioner compressor. Remove the air conditioning hoses from the compressor. Remove the retaining bolts from the air conditioner compressor.
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
Remove the air conditioner from the wall or from the window place it on the ground remove the covers get the hose out and hose the back of the air conditioner off, if it is a older unit it could be heavy depending on the size.
Under the battery , Remove the battery and the cover for the relays with a 20 torx and you will find the relays .
If it smells sweet ,it is coolant, and the heater core has failed. If it smells electrical you have a wiring problem and need to remove whatever is necessary to find cause.
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
Begin by removing the air conditioning condenser belt. Remove the air conditioner hoses. Remove the air conditioner condenser retaining bolts. Reverse the process to install your new air conditioner condenser.
The cooling fan relays (there are three) on this model are located in the maxifuse panel under the hood. Its location should be documented in your manual. If not it should be located above the air cleaner. You may also have to remove the air cleaner to remove the shroud guarding the maxifuses and relays.