I have a 2002 Genesis I and I have to hit the reverse button a couple times to get it into gear. If the light is flashing it is on in reverse that is why you don't have power i n reverse
It is flashing because the automatic transmission control unit has detected a problem. Seek professional help immediately.
Problem with the auto tranny.
The light is flashing because there is a problem. The problem will need to be diagnosed and repaired to stop the flashing.
lights flashing on an a/c control head usually indicate a pressure problem in the .c system. possibly low on freon
The O/D off light flashing indicates that the powertrain control module has detected a malfunction - have the Explorer scanned for trouble codes in order to diagnose and repair the problem
The powertrain control module has detected a malfunction - could just be a sensor problem
Check engine light? Usually indicates a problem in the emission control system - have vehicle scanned to determine the problem
I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
When the hold light is flashing, it means there is a problem with the transmission system. The problem can be various things including the transmission is locked in a gear and can be caused by overheating or a speed sensor problem.
The obvious answer is just to set the time. But if that's too complicated, or it happens too frequently, place a strip or two of black electrical tape over the display, and it will stop flashing. Of course, if you actually need to know the time, this could be a problem.
How can solve the problem of display of loading compan of tally 7.2
one of your doors or bonnet not shut we had the same problem but they will only flash on double locking
You have a problem with the memory card.
1. You have a problem with the cruise control. or 2. If your check engine light is also on, get the code read, cancel the light and the cruise indicator light will probably quit flashing and the cruise will start working again.
The dash displays information show the real time condition of the car. The warning lights help to show you if there's a problem with the car or the gas is running low.
Cable Failure Corrupt Driver Check Power Switch Shot Displays(worst case scenario) Nothing else I can think of......
The check engine light is flashing due to a problem with the emission system. I flashing check engine light usually indicates a random engine misfire.
how does nasa satellite photograph display the growing problem of ozone holes
out of balance
It is both. You input a problem and it displays the answer.
I have the same problem. any resolution
Its due a Service , or there is a problem
There's a TSB on this problem.
You have a problem with the charging system.