0
2001 cavilar left rear turn signal wont work i replaced bulb and checked fuse still wont work can you help?
Wiki User
∙ 16y ago
Check for a bad socket Turn signal flasher? Switch at steering column?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
You have a 1983 Chrysler e-class and both your turn signals and brake lights don't work you have checked your fuses and everything Why aren't They still working?
check the ground on your tailights R.W: Have you checked the turn signal switch? That may have to be replaced.
Why would your low beams not work if the fuses have been replaced and the headlights have been replaced and the relay box has been checked?
Often it can actually be a faulty turn signal!! As silly as this sounds it is quite common. First thing to do is clean the contacts on the turn signal, if you still get high beams and no low beams you probably need to replace the turn signal switch.
What should you do if you replaced brake pads and calibrators and still severe vibration occurs?
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
Replaced new washer pump and it still not working for a wrangler?
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
You replaced your alternator but your car still lost power?
Have the battery checked out. It may have a dead cell and not holding a charge,
Egr problems on 94 olds ciera My mechanic has replaced the egr. Checked all connections except cleaning the plenum. After all these checks the light still comes on. Any suggestions?
disconnect battery cables for minutes then reconnect them, this should reset signal in computer if problem has been fixed
You have 1998 Chevy s10 blazerLS The turn signals and hazard flashers do not work Fuses checked They are good Replaced 1 combination hazard flasher located behind glove box but still no change?
Replace the turn signal flasher first under the dash near the column but You may have a bad turn signal switch. On your model, the hazards and turn signals use the turn signal switch assembly. New $300+ ;salvage yard $ 40.00.
What can I do to fix the Right signal light on my 1998 Eddie Baur expedition i already replaced the bulb but the turn signal still does not work?
May sure the housing is good and not Corroded. If it is Corroded you may need to replace it.
Just replaced multifunction switch in 1998 Lincoln navigator because turn signals were not working Turn signal still not working What is the problem?
Did you happen to check the turn signal flasher before you installed the switch?
What could be wrong with turn signal if everything has been checked and they still dont workwhen i say everything i checked fuzes..bulbs..relay was changed under dash my four ways and breaks work?
Only thing left is two things: 1. Turn signal switch 2. Wiring between switch and fuses.
Why do my 2003 Audi TT turn signals work intermittently?
If your hazards still work, most likely your turn signal relay needs to be replaced.
How do you fix windshield wipers after you have replaced the switch and wiper motor and they still don't work on a 1992 ford escort?
Have you checked to make sure the fuse is good?
