0
What else can I help you with?
Why does the turn signals not work on your 1990 geo metro you've replaced switch and checked all bulbs hazards work?
Look at the relay for the flashers, that should fix your problem.
Why would blinkers still not work after you checked all fuses and replaced the blinker lever?
in mark 8's they use a controler to make flashers flash. this module has gone bad
What should you do if you replaced brake pads and calibrators and still severe vibration occurs?
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
My 1989 jeep wrangler turns over but does not start and the coils have been replaced and the wiring has been checked.?
The timing or crankcase sensor needs to be checked and most likely replaced.
97 Pontiac Sunfire with a rear right blinker problem I have replaced the bulb. The brake lights work tail lights work hazards work but the right blinker isn't working. Checked fuse also fine?
try replacing the flasher. there should be two, one for flashers and one for turn signals
What would cause the turn signals and emergency flashers to stop working on a 2003 JEEP Wrangler X. I checked the fuses and bulbs and they are good.?
turn signals and emerg flashers work off a flasher can. go to any auto store and buy a new one they are cheap and easy to replace
What would cause your turn signals and your emergency flashers to not work on your 1993 e150 ford van you have checked all of the fuses and they are all good?
Try replacing the flasher relay.
How to fix 4 way flashers on 1995 Pontiac sunfire?
I'm guessing that all of the light bulbs have been checked and are good. It's possible that you need to replace the flasher.
Why does your coolant light in your 2000 Chevy pickup keep coming on even after you have had it checked and there was no problem?
The sensor may be defective/broken. I would have that checked or replaced.
Replaced new washer pump and it still not working for a wrangler?
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
Why would thermostat on 1994 dodge Dakota leak after being replaced?
Was the gasket replaced? Have you checked the hose and the heater core. Is everything tightened down?
97 Ford F150 you hear clicking when you try to start it Battery checked good starter solenoid replaced ground wire replaced rebuilt starter and checked good What else can be wrong?
battery need to be at lease 14 volts to be able to start
