Look at the relay for the flashers, that should fix your problem.
Have you checked the bulbs themselves? The directional signal should be the same element as the brake light. Check to see if you rear directional signals.
The flasher module may be bad try replacing that first. If that is not bad replace the turn signal cam in steering column. the toggle switch would be very hard to do.
Could be 2 issues. Assuming the bulbs and sockets check okay, the signals may not work because the fuse or flasher is bad. The hazards could be a weak flasher relay. Then again it could be the signal switch is bad and effecting both functions.
it is either bad signal flasher or bad signal switch assembly try another flasher, swap the hazards one in place of the signals one if the hazards work right now if the hazrds dont work either then it is most likely worn switch assembly(common problem in these cars) i am working on a corsica right now that has no brake lights except the third one and it is the switch assembly worn out in it, flashers are good in it
i have replaced the fan, ( it does work when i attatch the code reader), the ac switch light does turn on, i have checked the fuses, all seem to be working, i am stumpted.
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
check out the flasher itself some are set to flash faster than others,switch out the hazards with the turns and see if hazards flash fast.
Did U checked the turn ligths flasher, switch and wiring?
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.
It could be the turn signal bulbs, some vehicles use separate bulbs for the hazard and turn signals. It could also be a bad switch or wires for the turn signals.
Perhaps problem in the steering column switch?
Blown fuse or bad flasher unit. Often, cars use different flasher for the turn signals and the flasher, so it is possible for the hazards to work and not the turn signals.
Bad switch? Bad hazard flasher?
Replace the turn signal flasher first under the dash near the column but You may have a bad turn signal switch. On your model, the hazards and turn signals use the turn signal switch assembly. New $300+ ;salvage yard $ 40.00.
Most vehicles have two flasher units. One for the turn signals and one for the hazards. If you have already replaced one try looking for the other one. Or check for a bad trunsignal switch
Did you replace the flashers? if not, that's the problem. They are located on the right of the fuse box, two round metal things. About the size of a large botle cap. Runs about 6 bucks for both.
check the ground on your tailights R.W: Have you checked the turn signal switch? That may have to be replaced.