Relaced the washer motor and it still does not work? Check the fuse, if it is good then you have a bad connection somewhere.
i would check the wiring for cracks
Replace it again!
$5
Try replacing the washer seat.
If your 1997 Chevy pickup wipers and washer pump are not working, you might actually have to replace the pump motor or the wiper motor, or both. These motors are not expensive to replace and can be purchased at most auto parts stores.
I just had mine replaced. Cost was $205.00 with labor. Air still isn't working I just had mine replaced. Cost was $205.00 with labor. Air still isn't working
i had similar problem with 99 wrangler and if its the relay its located in the fuse box.
egnine fan is not working on my 2006 Maxima 3.5 SL
If washer fuse is blown replace it first ,still washer not working ? One can check motor by following method unplug motor from Engine wiring and connect to separate 12VDC supply from Engine Battery if it does not moved throw & get new one. Maxmagic
I have a Model A-510 still working and it was purchased in 1981.
blower motor in dash was not working replaced it still not working now what
I replaced the crank sensor and the cam pick up that is under the distributor cap and still the wrangler wants to stall or back fires and bucks at 1200 to 2000 RPM when accelerating
Maybe a O2 censor.
i would check if you have power to the motor from the switch
There could be a switch that has gone bad in the headlight. The entire assembly will more then likely need to be replaced.
A turn signal not working on a 92 Chevy Lumina may be out because of a burnt out bulb. If you replace the bulb and it is still not working, the turn signal switch may need to be replaced. You can get the switch replaced by a mechanic.
check the fuses and relays
My CD player(radio) just stopped working, the back light still lights up but that's all it will do? I replaced the fuse, but still nothing, any ideas?
Since you replaced the sensor, and the speedometer still isn't working it is possible that you will need to replace the speedometer cable. Check the cable first to be sure that it is still properly connected, and if so replace the cable to see if that solves the problem.
I'm sorry I can't give an answer, because I have the same problem. I replaced the wiper motor, but no change. Also, my rear washer stopped working when the wipers stopped. I found that if you short the leads in the back the wiper will run continuously when the ingnition is on, but the washer still doesn't work. If you find an answer, please let me know.
Yes but it needs to be changed VERY SOON
First you have to see if your blower motor is working or not. If it is and still you have no heat then your heater-core is blocked and needs to be replaced.
The first thing to do is check the warranty on your appliance. If it is still under warranty, follow the instructions. Sometimes the shop where you purchased the appliance has a repair department which could help you or direct you to the place that the manufacturer recommends.
If it's the back window washer that's not working, I had the same problem. Seemly the tube that carries the water to the rear window has become detached. How i realised this was that I had refilled the water container and still couldn't understand why the window washer arm was working but no water coming out onto the window. Then my back seat was wet. It was because the water was being pumped when I pressed the back window washer switch. Something made me turn around and you wouldn't believe it. The actual water was coming out of the top of the left back passenger seat belt near the top of the window. I still have to get this fixed. But it might be the answer you are looking for. My back seat has remained dry since realisation of this has prevented me from switching on the rear window washer.