0
2001 dodge ram van both brake lights are on abs put new everything on in front and changed sensor on top brake light in backwhat do I do?
Wiki User
∙ 17y ago
Bring to a shop that has an ABS scanner for diagnosis
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
If you have changed erg valve o2 sensor gas cap but engine lights back on what can you do?
I changed erg valve o2 sensor and gas cap but lights back on what do I do
Where can outdoor sensor lights be purchased from?
Outdoor sensor lights can be purchased at most home improvement stores. Home Depot and Lowe's both sell outdoor sensor lights in their stores and online.
When the check light is on why would the overdrive light come on and blink?
Have your TRS (transmission range sensor) checked out. I had the same problem. Took it to a mechanic where he diagnosed everything and then changed out the sensor = $150.24 (sensor was $51.99, rest was diagnisis & labor.
What is a dark sensor?
A sensor that is activated by a lack of light (the dark). Usually these can be found in night lights that turn on when the lights are turned out.
Why would the idle jump in your 1996 Nissan 200sx I have already changed the throttle positioning sensor and I have tried everything else I can think of?
Vacuum leak ?
What is the problem if ABS and brake lights on the dashboard in VW Passat light up?
I had a similar problem except that with mine the ABS and ESP lights were on. Suggestions on the internet was that the ABS pump needs to be changed and the cost is around £1000. However a friend of mine diagnosed the fault as follows using diagnostic equipment: 1) ECU does not know/is not allerted when the brakes are applied He suggested putting a new brake switch 2) Left speed sensor giving innacurate data. He suggested a good clean of the sensor but mainly the area around the sensor. After cleaning the area around the sensor, the ABS/ESP lights remained on. However upon fitting a new switch all lights on the dash board was off and the car is fine. My mate mentioned that people are too quick to start changing parts on a car when the actual problem is a very simple one. A new sensor if I had changed would have cost me £110!! Hope this helps I had a similar problem except that with mine the ABS and ESP lights were on. Suggestions on the internet was that the ABS pump needs to be changed and the cost is around £1000. However a friend of mine diagnosed the fault as follows using diagnostic equipment: 1) ECU does not know/is not allerted when the brakes are applied He suggested putting a new brake switch 2) Left speed sensor giving innacurate data. He suggested a good clean of the sensor but mainly the area around the sensor. After cleaning the area around the sensor, the ABS/ESP lights remained on. However upon fitting a new switch all lights on the dash board was off and the car is fine. My mate mentioned that people are too quick to start changing parts on a car when the actual problem is a very simple one. A new sensor if I had changed would have cost me £110!! Hope this helps
What are some strategies on the best places to put motion sensor lights?
When you are placing motion sensor lights, you need to take into account the trees and bushes. Also placing them in places where they will be able to turn on if the sensor is triggered.
How do you activate motion sensor lights?
move around
Changed coil and module but still no spark?
crank sensor or cam sensor
Why do the brake lights on a 2003 Camry stay on?
1 of 3 reasons why, your head lights are on, your reflector lights are on ,or your brake sensor is broken
What is the difference between 2002 and 2005 dodge neon engine?
If you are asking about the 2.0L engine....the ECM was changed to what is called a NGC and the crank and tone wheel(pickup for crank position sensor) was changed. Also, the blocks are not interchangeable due to the position of the crank sensor was changed. It may be possible to change the crank and and sensor then extend the harness to reach the front of the engine where it was move from the rear starting in 2003 but this would be alot of work. Everything else on the engine should changeover fine.
What causes an interminit low idle stalling problem in a 1995 Buick Le Sabre Custom you have changed the inigination modler and the altinator The car stalls while restarting from a stop at red lights?
try replacing the throttle positioning sensor AND the low idle air sensor
