P0743-TORQUE CONVERTER CLUTCH SOLENOID/TRANS RELAY CIRCUITS This code will set if the voltage detected on the Torque Converter Clutch Solenoid Control circuit at the PCM is different than the expected voltage.
it happen too my 01 dodge Dakota the sensor is beside the throttle positin sensensor
A 1991 Dodge Dakota will have either a V6 or a V8 engine.
There is no difference in a 1995 dodge dakota with a 3.9 v6 engine and a 2000 dodge dakota with a 3.9 v6 engine and you can exchange the newer engine with the older one.
if its the 4.7 its oil sludge. i had to replace my engine. poor design
A possible cause could be that you have a clogged heater core.
Trouble code P0743 means: Torque Converter Clutch Solenoid Circuit Electrical
Yes, depending on engine SIZE. (;
Yes. A 3.9 v6 engine from a 1995 Dodge Dakota will fit into a 2000 Dodge Dakota with a 3.9 v6 engine. You will have to swap the intake and exhaust manifolds along with all sensors and fuel rail though.
It ran out of gas
my 96 dodge Dakota wont idle when engine is warm and i changed idle air controle valve what else could be wrong
A Dodge Dakota with a 4.7 takes 6 quarts with a filter change
Dodge does not have 4.3L engine. A 3.7L was not used in a 2000 Dakota. So no.Dodge does not have 4.3L engine. A 3.7L was not used in a 2000 Dakota. So no.