solid yellow is plus
Blue wire with a black stripe in radio harness.
You take the Jeep to a certified mechanic!
There are transmission speed sensors on the transmission and abs speed sensors at the wheels. The speedometer signal comes from the abs system.
yes you can but will need to make new wires to got to speedo signal and fuel gauge if the wires are not there. would need a gray plug, This is the wire code for gray plug. grey connector info, in the brackets is the equivalent earlier MID pin info (Y=Yellow con and B=Black con) Pin1(Y2) - Brown - To Chassis (0V) Pin2(Y3) - Blue/White stripe - Outside temp sensor Pin3(Y4)- Blue - Outside temp sensor Pin4(Y5) - Black - To F15 (15A) Pin5(Y1) - Red - To F12 (20A) Pin6 - Green - RPM signal, needs to be conecter to dash. Pin7(Y7) - Grey/Yellow stripe - Instrument Illumination (dimmer controled) Pin8(Y8) - Red/Grey(white) Stripe - Radio (aerial power feed i.e. Radio on indication) Pin9(Y9) - Brown/White Stripe - Radio Serial Interface Pin10(Y10) - Brown/White Stripe - Radio Serial Interface Pin11(Y11) - Brown/White Stripe - Radio Serial Interface Pin12(B8) - Blue/Black Stripe - Fuel level sender Pin13(B11) - Brown/Grey Stripe - Oil level sensor Pin14(Y14) - Brown/White Stripe - To pin 8 of diag connector (to support programming) Pin15(Y15) - Black/Yellow stripe - To check control Pin16(Y16) - Black - To F2 (15A) Pin17(Y17) - White/Green stripe - To check control Pin18(Y18) - Black/Yellow stripe - To check control Pin19(Y19) - Yellow/Red stripe - To brake pad wear sensors Pin20 - NC Pin21(Y23) - Grey - To Auto transmission Pin22(B10) - Brown/Yellow Stripe - Washer Level sensor Pin23(B5) - Brown/White Stripe - Computer stalk buttons Pin24(B6) - Brown/Red Stripe - Computer stalk buttons Pin25 - NC Pin26(Y12) - Blue/red stripe - Speed signal (from ABS controller) Pin27(B9) - Black/Brown Stripe - ECU signal Pin28(B3) - Brown/Blue stripe - Coolant level sensor Pin29 - Black/Violet Stripe - To Hid lighting Pin30 - To Diesel fuel pump (X20DTH only)
Look for speed sensor wiring at the front wheel bearings. If you have front speed sensors, you have abs.
po320 is the engine speed circuit malfunctioning.( AKA) crank sensor.
According to the wiring diagram that i have - there is no specific fuse for the Vehicle speed sensor.There are 2 wires coming out of the vehicle speed sensor, one is Yellow and one is Purple. They both go to the powertrain control module. (which is located on the left side of the steering column under the dash.) The Yellow wire coming out of the vehicle speed sensor is number 64 on the PCM and is listed as VSS Hi(signal). The Purple wire coming out of the vehicle speed sensor is number 65 on the PCM and is listed as VSS Lo(ground). If the Transmission Speed Sensor is bad you should set a diagnostic trouble code and the speedometer will not work.
No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.
The speed sensor wire is connected to the speed sensor and goes to the speed sensor relay switch. The speed sensor relay switch is connected to the computer by a separate wire.
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.
Remove the wiring harness from your speed sensor. Remove the speed sensor retaining bolts. Reverse the process to install your new speed sensor.
A "speed" sensor can affect the shifting of the trans.A "speed" sensor can affect the shifting of the trans.