answersLogoWhite

0


Best Answer

I'm just making a guess here. There is a instrument panel dimmer switch on the multi-function lever on the left side of the steering wheel. This lever incluces turn signal, head lights, parking lights, hi/low beam, instrument panel dimmer, dome lights, and maybe some other stuff. One you figure out how to activate the dome/courtesy lamps, just back that part of the switch off one click and that is the maximum dashlight level setting.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 2004 Jeep Liberty Sport What could cause a loss of all the instrument cluster lamps when the fuse tests good The Dome lights work but no cluster lights in the dash radio blower or shift console?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a blower motor for a 2006 jeep liberty?

The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed without having to remove the instrument panel or the HVAC housing.Disconnect and isolate the negative battery cable.Disconnect the wire harness connector from the blower motor .Release the locking tab that secures the blower motor to the HVAC housing and rotate blower motor counterclockwise.Rotate and tilt the blower motor as needed for clearance to remove the blower motor and wheel from the HVAC housing.


What fuse is for the blower motor on 2004 jeep liberty?

What fuse number for 2004 Jeep Liberty blower motor?


How do you remove the dash panel moulding around the instrument cluster on a 1998 gmc jimmy so the blower switch can be replaced?

pry and pull it off by your bare hands its just that simple


Where is the blower resistor located on a 1992 BMW 525i?

Blower resistor is under Drivers' side of center console


How do you replace the blower motor in a 2006 Ford Taurus?

See "Related Questions" below for a different set of instructionsDisconnect the negative battery cable.Disengage the instrument panel insulator from the instrument panel.Detach the wiring connector at the blower motor.Unsnap the instrument panel upper finish panel from the instrument panel.On vehicles equipped with autolamp, Detach the electrical connector from the light sensor amplifier.Unsnap and remove the instrument panel finish end panel from the right side of the instrument panel.Remove the 3 screws retaining the instrument panel to the upper cowl top panel.Remove the 2 screws at each right side of the instrument panel.Remove the 3 screws retaining the blower motor to the evaporator housing.Pull the instrument panel away from the cowl and remove the blower motor from the A/C evaporator housing.If required, separate the blower motor wheel from the blower motor by removing the retainer from the blower motor shaft and sliding the blower motor wheel off the blower motor shaft.


How do you Remove blower motor 2005 dodge status?

Remove the instrument panel silencer from the passenger side of the instrument panel. Disconnect the wire harness connector from the blower motor. Remove the three screws that secure the blower motor to the HVAC housing. Remove the blower motor from the HVAC housing by rotating and tilting the motor as needed for clearance of the blower wheel....


Signal relay Volvo 240 1989?

Behind the center console to the left of blower.


Where is the blower switch located on the 1999 Pontiac Sunfire?

the blower switch itself is located in the instrument panel. it adjust the speed of the blower. the blower resistor, if that is what you are looking for,is located beside the blower motor under the pass. side of the dash


Where is the blower resistor located on a 1992 BMW 325i?

The blower resistor on the 1992 BMW 325i is located under the center console. It is found on the driver's side.


Where is the rear blower motor located on a 2004 Chrysler Pacifica?

between the seats, under the console


If Blower resistor is bad will it drain the battery on a Jeep Liberty 2002?

Yes.


How do you make ac leak in car?

v have to check the blower motor,ac pipe lines and cluster assembly