sounds like the flywheel could be lose. does it do it all the time while driving or just shifting
no the bell housing is different as is the spline for the clutch
That involves removing the axles the tranny. I just replaced the clutch and tranny on my 95 tercel and it's not fun.
unbolt tranny from engine clutch is between them
Could be bad hydraulics? Possible it just wore out. or tranny fluid, tranny seal, clutch pads, tranny silinoid. autozone.com has an online q&a about autos, check it out
don't try to put trans fluid on clutch. manual tranny uses 40wt oil.
No, tranny comes out the bottom.
The 400 tranny on a 1983 Chevy 6.2L K20 diesel have very high pressure.
A transmission that does not use a clutch and pressure plate to disconnect from the engine.
Bad reverse clutch in the tranny
That's pretty much a given with changing any clutch or torque converter.
have to completely pull tranny and 4 wheel diff.then replace clutch and re-install back in. Not for a novice,may want to leave this one to the tranny man.
Drop the tranny. I replaced a clutch on an '89 Ford 4*4. There is a lot less to undo & do-up on a tranny. Just get some help & a few jacks, drop the drive shaft, and then drop the tranny. Line up your new clutch and use 3 or 4 jacks to raise your tranny evenly twist the shaft till she lines up, give her a shove and bang, put your tranny bolts in, drive shaft, you're on the road or mud. FYI, it will take about a day. ~Shade tree