Timing marks are on the top of the timing gear rear cover. With the cover off, these marks will line up with the timing marks on the intake and exhaust gears when the crankshaft gear timing mark faces down to its mark at the bottom. Good luck!
The cam gear timing marks for a Isuzu 320 V6 are located on the cam sprocket and the timing chain itself. The marks must be aligned with each other to ensure proper initial timing.
where are the timing gear marks on a 1997 chev s10 2.2 located
Where are the timing marks on the cam gear on ford 2.9 engine
it has timing marks on it, look!
the timing marks are not on crankgear on cam gear Chevy Lumina 3.1 1995 would it be keyway to keyway
The timing marks for the cam sprocket on a 98 S10 is on the front. The marks for the crank shaft is on the oil pump gear.
ignition timing marks are on front cover above crank pully. Timing belt marks, above crank gear at 2 o'clock position there is a notch, and top cam gear has hole which lines up with hole in cover with 1\8 drill bit.
you have to pull your timing cover off and line up the timing marks on the cam gear and the crank gear auto zone.com has all the info on how to do it
ford doesnt put timing marks on anything. u need a special cam gear alignment tool
on the balencer there is a timing mark and om the motor theres a tab there is also a mark on the cam gear, when lined up, both marks on the crank gear and cam gear point up.
If memory serves me correctly, the timing marks will be behind the timing belt cover. There will be marks on the gears and also marks on the block. Line the top gear with the top mark and the bottom gear with the bottom mark. Please note that you will need to undo the battery for a few minutes and then reconnect. This allows the computer to reset itself. Hope this helps