Cylinder is bad need toreplace
Place the key into the ignition. Turn the key to the auxiliary position, without starting the engine. Keep the key in the auxiliary position for 30 seconds. This should reset your antitheft system.
turn the key from the off position to the on position without starting the car 3 times, finishing with the key in the on position but without the engine running. this enables the check engine light to display any engine fault codes.
To clear the light put ignition in the on position for 5 minutes. Turn ignition back to off for one minute. Then start the vehicle light should go off. This works if the key is the right key for the vehicle and there are no serious problems. Tim
The key has to be turned to the "Run" position, but the engine should not be running. The key has to be on to power up the ECU.
Turning the key to only the on position, the pump will only run for a couple of seconds to prime the system. Turning the key on and starting the engine, the pump will run and keep running as long as the engine is running.
Bad ignition switch?
Key in on position (not running) accelerator to the floor 3 times
Have you tried changing the ignition switch?
Vaccuum
Because it will stop and then car will braked . Engine will be blow up .
check the chip in the ign key. Try another key if available
11 and they cost over 35.00 to replace