answersLogoWhite

0


Best Answer

Check for vac leaks. A can of starter fluid helps. When you hit the sweet spot, you will hear the difference.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 91 Chev Surburban you replaced intake manifold gasket now has a high idle and running rich Maybe throtle body gasket?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause a squealing sound if it is not the brakes or belts when engine is running on idle condition?

Check for a vacuum leak around the throtle body and intake manifold.


Does the 1990 Buick Electra have a PCV valve and if so where is it located?

Yes, it is located in the intake manifold behind the throtle body.


Where is the PCV valve in Toyota Corolla 2001?

It depends on which engine you have but it should be in the intake manifold. There should be a hose going from it to the throtle body.


What would caused 1990 safari to quit running change fuel pump now getting fuel to throtle body will not start you spayed carb cleaner runs until you quit spraying any answer?

Throttle body needs to be replaced


Where is the fuel filter located on a 1993 Ford Escort?

were the fuel line comes out of the tank running to the throtle body


1991 Nissan truck v6 blowing black smoke running rough when you give it more than quarter throtle?

It's running too rich.


Your car keeps shutting off when you take your foot off of the brakes why is this happening?

check for bad manifold or throtle body gasket. loss of vacume can stall vehicle


How do you install a fuel injector on a 99 Chevy Suburban 1500?

You have to remove the throtle body, plastic intake plenum, and carefully remove the spider looking plug from the intake manifold.


What might the problem be if a 1999 Mercury Mountaineer is starting to stall when starting?

Clean the inside of the throtle body where the butterfly is. Also clean the idle speed control which is on the side of the throtle body. Good luck. 11/11/04 - just happened to me. My mechanic is going to; 1) replace EGR valve He also found a leak (with a special leak detecting gadget) at the intake manifold, so that gasket is being replaced. Check your pcv valve, this on thing can cause a lot of troubleshooting. Only 3-5 dollars to buy.


Why would a 1998 Ford Windstar start running only at high rpms?

Either the throtle cable is hanging or the idle control solonoid is not working


Where is throttle position sensor on 1999 ram 1500 dodge ram?

Driver side of the throtle body.Driver side of the throtle body.


How do you change the number 2 spark plug on a 2002 Nissan Xterra?

the best way to do the right bank plug is to remove the upper intake manifold with throtle attached. It only has five Allen screws.