on your 91 sonoma it is most likely the connection at the fuel pump. a common thing the hot wire burns out. had to buy a new connecter and cut the old one off and wire the new one on.
this might fit , you will have to see where the vent port is , also where the lines and filler neck connects if they are the same
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
The temperature sensor on a 1998 Sonoma is located in the engine compartment just to the left of the distributor. Look for a plastic part that looks like a bolt that is held on with a clip and a small wire harness. It is on the top of the manifold.
Its on the transfer case by where the front axle connects. It's a thin case with a motor mounted on it.
Removal of the cooling fan on a 2002 GMC Sonoma 4.3l begins with disconnecting the battery, removing the wiring harness to the fan, and taking off the protective shroud. The fan can then be unbolted from the frame and removed.
The pad on the clutch is getting low
Im getting 17.5mpg in my 2003 sonoma z-r2
don't know your ansur but can help you out frist test your wires with a metter then oo wait did you check your bubbs some time they go out then
Sonoma is a historically significant city in Sonoma Valley, Sonoma County, California, United States, about 50 miles north of San Francisco.
The address of the Sonoma Valley Regional Library is: 755 West Napa Street, Sonoma, 95476 6412
I have a 1993 GMC sonoma truck that came with a digital instrument panel and i want to change to a standard panel. can this be done without changeing the wire harness or plug.
The address of the Sonoma League For Historic Preservation is: Po Box 766, Sonoma, CA 95476-0766