Cars & Vehicles
Brake Pads and Rotors
Chevy Silverado
Ford Explorer XLT

93 Pontiac drum brakes?

282930

Top Answer
User Avatar
Wiki User
Answered
2006-07-19 20:51:10
2006-07-19 20:51:10

What about 1993 Pontiac drum brakes, please be specific.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You have to get a special socket at the auto store.

I don't know about the Isuzu, but the 93-97 Altimas had front disc brakes and rear brakes were standard drum, or optional discs.

1993 deville does not have drum brakes only disk broughm models have drums use a hammer and flat blade screwdriver inslall flat blabe behind drum and backing plate and pull out and hit thd drum at same time sevaral times use some force hind it hit it hard

Since no one should really want to disconnect their brakes, this question might be asking how to repair / replace rear brake pads or shoes.Assuming that to be the case, See "Related Questions" below for more about rear drum and disc type brakes on Taurus / Sables.

A Lincoln Town Car uses hydraulic brakes, not air brakes.

Rear brakes come in two types: disc or drum. See "Related Questions" below for more specific details for both types...

Parking brake? Service brakes? Pedal dropping? Bad Master cylinder? ABS Module?

I don't mean to be glib or sarcastic, but when I bought my new rear brakes at a chain auto-parts store, for a few dollars I got a Rear Drum Brake Kit made specifically for my '93 Cherokee Country. With the kit are picture directions that can explain better than just seeing it in text. You will also want a brake spring remover (nominal cost, ask the clerk) and a needle-nose pliers. Good luck!

That usually means that the ABS control module has detected a problem with one of the sensors or actuator. It also means that you only have regular brakes and that your ABS isn't working.

Have you checked the brake fluid? You might have to change master cylinder or you might check to make sure there is not a vacume leak.

Listed in your owner's manual and on the driver's door post.

lokks to be on the lower right side of engine

The wheel bolt pattern is 5x115

You need to adjust the cable on the brake.

buy good pads, and install and have rotors machined

I had this happen to me. It turned out to be a corroded earth terminal.

You need new brakes. IF its really bad you're going to need new rodars.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.