Seized Engine? Loose or corroded battery cables? Bad starter? Bad starter solenoid? Dead battery? Bad neutral or clutch safety switch?
A 1987 4-speed ford ranger with over drive is a 4wd and not 2wd.
try harder. if you tried everything you'd be over him already.
depends get more specific.. head over to www.ranger-forums.com for more answers
On the 2.3 litre Dual Over Head Cam four cylinder engine in a Ford Ranger : Ford started using that engine in the Ford Ranger during the 2001 model year
If you have the 4.0 L EFI V6 ( which is an Over Head Valve design ) in your Ford Ranger ( I believe it is 157 / 160 horsepower ) My brothers 2007 Ford Ranger , which has the 4.0 L Single Over Head Cam V6 engine is rated at ( 207 horsepower )
no , over head valve ( pushrod )
Does it turn over? Does it have fuel/spark/compression?
Behind the seat. It may have a cover over it.
install 99 tail lights and there is no issue.. head over to www.ranger-forums.com for more answers
whats stated below is WRONG... all 97+ will swap fine... head over to www.ranger-forums.com for more answers No they will not. I have been working on rangers for a long time. the only ones that will fit should be 98 to 2001. ford changed mostly everything on these trucks. 2002 and 2003 parts will interchange but that's it.
1995 ford ranger 4wd cranks over but no spark, replaced crank sensor Check battery power to coil connector, if that is good coil can be tested w/multimeter.
On a 2001 Ford Ranger : The 4.0 liter Single Over Head Cam , V6 engine has ( 3 ) timing CHAINS