check to make sure your fan is comng on ,and you may also want to change your tempture control unit,,on the end of the head,,its alot cheaper than replaceing the head,,
The thermostat on a 2004 Chevy Venture is changed by draining the radiator, removing the upper radiator hose, and unbolting the thermostat housing. The old thermostat and gasket can then be removed and replaced.
I suspect that either your thermostat is plugged with debris from the radiator change or that the thermostat was replaced backwards. The spring side should be towards the block.
The thermostat housing on a 2008 cobalt where the lower radiator hose connects to the radiator.
thermostat is located under radiator cap!
To change the thermostat in this Lexus model, follow the upper radiator hose to the aluminum housing--the thermostat is located in that housing.
To change the thermostat on a 2002 Montero Limited, drain the radiator halfway through the plug on the bottom. Remove the upper hose assembly and unbolt the thermostat. Install the new one and fill the radiator.
Drain the water from your radiator. Remove the radiator hose, from the thermostat housing. Remove the thermostat housing retaining bolts. Replace the thermostat housing gasket and reverse the process to install the new thermostat.
To change a thermostat on a 1994 Toyota Camry V6, drain the radiator partially. Remove the upper hose assembly, unbolt the thermostat, and put the new one in place. Refill the radiator completely.
You need only to drain off a couple quarts of coolant to change the thermostat.
It is very simple to change the thermostat in a 2004 E 150 Van. The thermostat can be found by following the upper radiator hose. After the thermostat is found, disconnect the radiator hose and drain it. Then, you will remove the two bolts that are holding the thermostat housing place. Remove the old thermostat and replace it with a new one.
Drain the radiator down 1/2 way. At the engine end of the top radiator hose is the thermostat housing. Remove the housing and install a new thermostat.
Drain the radiator into a container. Remove the upper radiator hose at the engine. Remove the2 bolts on the thermostat housing and lift it up. Remove the thermostat and clean the surfaces. Install the thermostat and the bolts. install the top radiator hoes and fill the radiator.jd