0
um if it will not idel but start but you have to keep giving it gas... unplug the injectors and try starting it while pumping the gas if it starts you have a leaking injector... if this does not work it could be a bad egr ... or Idel Air Control Valve.. IAC ? hope this helps
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How many mpg in a 4 cylinder s10?
My 1998 S10 2.2L standard 5 spd averaged 28 mpg.
You are preg when do you have your anti d injection?
About 28 weeks
What is the freon capacity for a 2000 Chevy s10 pickup?
1.75 pounds or 28 oz
When swaping the engine from a 1985 S10 28 to a 1983 S10 28 will the transmission be the same?
The transmission will be the same because from 1982-1990 GM used the same transmission in the S10 Blazer and S10 Pickups from what i have been told is even though the engines are the same size the trans might not be interchangable with your 83 model. because im going through the same problem my 85 s10 needs a 700r4 ,but it want interchange with every model of 2.8 engines,so if you know the answer to this please let me know.
How many splines are on an axle from a 1989 S10?
I believe 89's and up have 28 spline axles.
What are the release dates for Animal Cops Houston - 2003 Insulin Injection?
Animal Cops Houston - 2003 Insulin Injection was released on: USA: 28 September 2009
What is the torgue spec for a 2003 Chevy s10 4x4 wheel bearing?
The torque specs for a 2003 Chevy S10 4x4 wheel bearing is 28 ft. lbs. This is equal to 38 N.m.
Your 1983 S-10 28 wont idle?
vacuum hose leaks off the carburetor.
How do you put a clutch in a 93 S10 with a 28 in it?
youy bestbet is to go and buy the book. it will have every bit of information for your truck. Autozone.com has a repair guide that is also somewhat helpful.
What is the ignition timing set at for a 1979 928 Porsche?
26-28 Before Top-Dead-Center (BTDC) in euro model at 3000rpmapprox. 8 degrees at idle
What is the fuel pressure for a 1997 ford f150 4.6 liter?
35-40 psi while engine is off. 28- 35 psi at engine idle. -jonny b.
How do you change the front automatic transmission seal on a 1987 Chevy S10 Blazer with a 28 v6?
big job you have to remove trans or at least back it out enough to remove torque converter cause its behind it
