0
94 Lincoln Continental why is your new serpentine belt is to big?
Wiki User
∙ 13y ago
Please make sure that it is routed the right way and for that year vehicle.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many belts does a 2006 Chevy Malibu?
should have 1 big belt called a serpentine belt.
Why does a serpentine belt fall off?
It is important to have proper fitting parts on a car. A serpentine belt will fall off because it is worn out, or because it is too big for the car.
Why is the serpentine belt keep coming off the 1992 Chrysler fifth avenue?
Your belt is either to big or just plain worn out.
What should it cost to replace a 1999 Chevy Suburban serpentine belt?
I paid $169 at Big O.
How do you replace serpentine belt on 1991 Bonneville?
you have a belt tensioner you need to put a big socket wrench on it and push down on it and it will lift it up to release the tension on the belt. do the same thing to put it back on
Where to find the alternator belt on a Mitsubishi Eclipse 97?
Alternator belt would be the serpentine belt.. the big one that goes around all the crap... The only other belt should be around the timing... and that should be covered by plastic.....
How do you tighten a serpentine belt for a 1998 Ford Contour?
Buy a Chevy!!!! That was a big help. Most but not all serpentine belt systems have a spring loaded tension pulley that just holds constant tension on the belt. If there is a tension pulley, it will be the one pulley that is not attached to anything like the alternator or AC. After that, the alternator is the most likely to be the one that adjusts.
How do you change the fan belt on a 1995 Grand Am SE?
You will have to remove the motor mount which the fan belt runs through. The motor will have to be supported underneath with a big block of wood and a jack. A serpentine belt tool (rent for free from Canadian tire) will be needed to get the belt on.
How do you replace the tensioner belt on a 2002 Chevy Trailblazer?
The serpentine belt is replaced by relaxing the tensioner arm using a big wrench or screwdriver. Then pop the belt off and slide the new one on. www.trailvoy.com Trailblazer enthusiasts with all the answers!
Have replaced the Serpentine Belt on a 1990 Jeep Cherokee Routing seemed fine but belt keeps slipping slightly and is being cut into by something Should you re-route or could it be another problem?
belt is probably to big, try a 1 or 2 inch smaller belt.
How do you adjust the tension of the Serpentine belt on a 1995 Pontiac Transport with a 3.8 Liter Engine?
Automatic belt tensioner - if not enough pressure replace tensioner Belt has streched too big, and the Automatic belt tensioner is at its limit. The tentioner is how yo remove the belt, so you should feel its tention with your wrench.
How do you replace the serpentine belt on a 1999 Buick Regal?
Best to get a shop manual for this operation, if you have not replaced it before. Usually there is an "Idler Pulley" on many late model cars that is "spring loaded". You "Bias" this pulley using the big nut in the middle of the pulley (usually with a socket wrench) so that the serpentine belt has enough slack in it so you can remove it. Install new belt by reverse procedure. TommyTrouble
