0
94 grand am quad engine the engine will start and then stops running will stay running if you rev it over 1500 rpm help The crank position sensor has been replaced and it has 40 psi fuel pressure?
Wiki User
∙ 9y ago
A dirty air filter can cause your engine to stall out, or only run at higher rpm's. Try changing the air filter to see if the problem clears up.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Why does the fuel pump on a 91 Ford F-250 with a 5.0 engine run constantly with the engine not running but the key is in the on position.?
Fuel pressure regulator, or a stuck relay.
You just replaced the engine in your 1999 Tahoe with anew engine what should the oil pressure reading be at running temp?
NNo less then 55 PSI. and no more then 62 PSI. Factory specs. are 55 to 62 PSI. NEW ANSWER: hey I'm sorry the answer that I just give you is the fuel Pressure for that engine. You should have at least 25 to 30 LBS. after engine is at running temperature- HOT Higher pressure is okay too. This is OIL pressure.
Change a throttle position sensor for 05 altima?
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
What is fuel Pressure for a 1993 Ford Escort 1.9L?
If the engine is not running the pressure should be 35 to 40 psi. If the engine is running the pressure should be 30 to 45 psi.
What is the fule pressure for a 2000 Chevy Blazer?
Key on Engine not running 55 - 61 psi. Engine running pressure should decrease 3-10 psi.
What is idling fule pressure for a 1995 s 10 with 4.3 vortec?
With key on engine not running pressure should be 9 to 13 psi Engine at idle pressure should decrease by 3 to 10 psi on a throttle body. On a multi port injection key on engine not running pressure should be 41 to 47 psi. Engine running at idle pressure should decrease 3 to 10 psi. Central multiport fuel injection key on not running should be 58 to 64 psi. Engine running at idle pressure should decrease 3 to 10 psi. Central sequential electronic fuel injection key on not running pressure should be 55 to 61 psi. Engine running at idle pressure should decrease 3 to 10 psi.
What should fuel pump pressure be with the engine running?
The fuel pump pressure may vary by vehicle. However, on average the fuel pump pressure with the engine running should be between 4-6 psig.
What is the purpose of the pressure gauge in a car?
For the operator to monitor the oil pressure of the engine. If the oil pressure drops below average when running, the engine is in trouble.
What are the fuel pressure specs for a 95 Chevy blazer?
key on engine not running 58-64 psi engine running at idle pressure should drop by 3-10 psi
What is the fuel pressure for a 99 ford escort zx2?
50 to 85 psi engine not running. 25 to 35 psi engine running.
What is a Blazer fuel pump start up pressure and engine running pressure?
you need at least 50 psi to run and 55 or so to keep it running thats with cpi engine the others use less pressure and a different fuel pump....
What happens if the oil dipstick compartment comes out of the engine when checking the engine oil in an 84 cutlass supreme?
If the place where the dipstick for the oil is comes out of the engine it will cause an oil leak. The engine might not be able to build up enough pressure to keep running either on the 1984 Cutlass Supreme. It should be replaced.
