It is just to the right attached to the head.
The Saturn EGR valve is attached to the head, directly above the transmission bell housing.
The EGR valve is attached directly to the head, on the drivers side. It's a round device that is bolted to the head. It's relatively simple to remove, just disconnect any wiring (there should be plugs) then remove the bolts.
The EGR valve is located on the drivers side of the head, just above the transmission bell housing. Remove the electrical and vacuum connections, then remove the two bolts that hold the EGR valve to the head. Use a NEW gasket when replacing the EGR valve.
It's mounted to the head, just above the transmission "bell housing". The position sensor is connected to the EGR valve. It's the part of the assembly that has the electrical connections.
All sensors, air pump, and EGR
Top right side of engine as you stand in front of the car
disconnect + battery cable..hold foot on brake for at least a mnute,,let go of brake pedal..reconnect battery cables..this resets the computer
Quite easily take off the air breather tube then there is a cone shaped part with a connector on top at the back of the engine rightby the accelerator cable 2 10mm bolts hold it on take off the 2 bolts and the valve comes off
26 is a quad driver (pcm) control for the egr valce and other things. 32 is egr valve. If you have 26&32 most likely the egr valve and/or solenoid need replacing. On a double overhead cam engine they are at the back of the engine valve is round with a vacuum line on the top follow the line 5 in to solenoid. On a single overhead cam it is under the breather box same shape but the solenoid is by the throttle body
The relay is attached to the starter and is an integral part.
yes
How can I replace the headlamp on a 2000 Saturn SL1