if that's the only code, then the sensor is most likely shorting while hot, and kills the ignition...so yes..also more diagnostics can be found in the book....
everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the REFERENCE section...make copies of the right sections...good luck :)
It will start and then you have to wait a half an hour and minute it will restart again.
1996 Chevrolet cavalier shuts off while driving and have to put in natural or park to restart
Yes. Cam sensor will determine the rotation of the camshaft, and if it does not sense it 'turning' the sensor will not allow the engine to start (it protects damaging the engine). Faulty camshaft or crankshaft sensors will stall engine and prevent restart until replaced.
My 2003 Chevy Tracker would not restart when it was hot and finally would stall & not restart until it sat and cooled off for 10 minutes. It would crank but not start. We replaced the camshaft it solved the problem. It was located at the back of the engine, at the top and is held by just one screw.
possbibly the fuel pump. located in gas tank
maybe ignition madual
crank senser....
to restart a PSP you have to.... attach it to your computer... then delete the files or restart it from there
this is a bit of a history lesson: On early computer controlled engines the cam sensor was only really needed when the car started so the computer knew where the combustion cycle was. They ran a cross check with the crankshaft position sensor to insure the calibration was correct but complete failure would not cause serious trouble until the engine was shut off and a restart attempted. Next level was when the manufacturers realised that if they measured the wear on camshaft drive components and or error in where the camshaft was timed they could make the engine run better and make less pollution. Now with variable cam timing on multiple camshafts the computer measures the camshaft rotation to adjust the camshaft timing.
symptoms of a bad sensor will be , engine cutting out then starting again as you drive. cutting out then being able to restart when vehicle is stopped. hard starting. if left long enuff before replacing, you will not be able to restart
widget restart bu ten using the my computer restart agent restart
ClickStartShut Down ComputerPress "restart"