My 2003 Chevy Tracker would not restart when it was hot and finally would stall & not restart until it sat and cooled off for 10 minutes. It would crank but not start. We replaced the camshaft it solved the problem. It was located at the back of the engine, at the top and is held by just one screw.
were is the cam shaft sensor
where is the camshaft sensor on a 2000 Chevy sliversdo with a 4.8L V8 motor
change the camshaft position sensor, workind on mine.
when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.
I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.
It's bolted to the back of the cylinder head (right side when facing engine) inside a casing....it has an electrical connector on it and it's attached to this casing by one bolt. Unplug the electrical connector, unbolt the sensor and replace in reverse...
repair timing chain on 2000 chevy tracker
The 2000 Chevrolet Silverado 1500 4 x 4 camshaft sensor can be found on the back of the engine head. The camshaft sensor will be labeled as such.
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
The camshaft sensor on a 2000 Saturn is located on the firewall side behind the lower engine assembly. The camshaft sensor is the last one with a connector facing the transmission.
where its located the oil gage in a 2000 Chevy tracker mortor 2.0
Same prob with 2000 Chevy garage says its the camshaft positioning sensor and no there are no codes when it does it they were suprized