answersLogoWhite

0

I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the camshaft position sensor located on a 96 Geo Metro lsi 4cyl?

It is in the diistributor.


Where is the camshaft position sensor located on a 3 cylinder 1999 Chevy Metro?

On a 1999 Chevy Metro with a 3-cylinder engine, the camshaft position sensor is typically located near the camshaft, often mounted on the front of the engine. It may be positioned near the timing cover or cylinder head, depending on the specific engine configuration. To access it, you might need to remove any components obstructing the sensor's location, such as the air intake or engine covers. Always refer to a repair manual for precise details and diagrams.


Installation of a crankshaft position sensor on your Chevy Metro?

it is located on the head


Where is the camshaft position sensor located in a 1992 Geo Metro Lsi 3 cyl?

inside of the distributor


How do you change the camshaft position sensor on a 2001 Chevrolet metro?

To change the camshaft position sensor on a 2001 Chevrolet Metro, first disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically near the camshaft or engine block, and unplug the electrical connector. Remove the mounting bolt and gently pull the sensor out. Install the new sensor by reversing the process—insert it, secure it with the bolt, reconnect the electrical connector, and finally reconnect the battery.


Where is the Camshaft Position Sensor on a 1998 Chevrolet Metro?

The Camshaft Position Sensor on a 1998 Chevrolet Metro is located on the engine, typically near the camshaft or cylinder head. It's usually mounted on the front of the engine, often near the timing cover. To access it, you may need to remove any surrounding components or covers that obstruct your view. Always consult the vehicle's service manual for precise location and removal instructions.


Where is the camshaft position sensor located on a 2001 Chevrolet Metro?

On a 2001 Chevrolet Metro, the camshaft position sensor is typically located near the top of the engine, often near the camshaft or under the intake manifold. It may be situated on the cylinder head or the timing cover, depending on the engine configuration. To access it, you may need to remove some components for better visibility and reach. Always consult a repair manual for specific instructions related to your vehicle.


How many ohms should a 1999 Chevy Metro crankshaft position sensor have?

The crankshaft position sensor for a 1999 Chevy Metro typically should have a resistance reading between 200 to 600 ohms when tested with a multimeter. Values outside this range may indicate a faulty sensor. Always consult the vehicle's service manual for specific specifications and testing procedures.


What should be done to stop a oil leak from a 99 Chevy Metro crankshaft position sensor?

the seal on the crank shaft needs replaced


Can you reuse the crank position sensor on a 98 Chevy Metro lsi?

Yes, you can reuse the crank position sensor from a 1998 Chevy Metro LSi as long as it is still functioning properly and shows no signs of damage or wear. Ensure that the sensor's electrical connections and mounting points are intact for proper installation. However, if you're experiencing issues related to the sensor, it's best to replace it to avoid potential problems. Always verify compatibility with your specific vehicle model before reinstallation.


Where is vacuum sensor located on a 1991 Chevy Metro 454 engine?

that must be some metro to have a big block


How do you install oxygen sensor for Chevy Metro?

you gotta take the old one out first