answersLogoWhite

0

96 Chevy Pontiac grand am high reving?

Updated: 10/23/2022
User Avatar

Wiki User

14y ago

Best Answer

Perhaps throttle plate is stuck open. try to "free " with a screwdriver or perhaps a vacuum leak

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 96 Chevy Pontiac grand am high reving?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes a Pontiac grand am to idle high?

did you find a solution yet


How do you fix a Code P0507 on a 99 Pontiac grand am 2.4L?

the p0507 is the idle control system (high rpm) basically your rev limiter which responds when your VSS (vehicle speed sensor is malfunctioning) causing the computer to think the engine is reving to high so it limits the throttle response limiting your rpm's (sense of no power when appying throttle)....hope this helps Arlen


What is the meaning of high reving engine?

Highly-inflated ego.


Is running an 02 Pontiac Grand AM at 2000 RPMs regularly when driving too high RPM?

NO


What is the high and low pressure in ac of a 2004 Pontiac grand am?

buy the book on your car car.


What is a stock Pontiac Grand Am headlight bulb?

It will depend on year of Pontiac Grand Am and whether you are looking for high-beam or low beam. See sources and related links below to lookup by make, model and year.


How high do you need to lift a 2000 Pontiac Grand Prix to fit 22 inch rims?

you dont.....


Pontiac Grand Am 2000 fan only works on high?

Check for a bad blower resistor at blower motor


How do i stop a Yamaha blaster from reving up high?

park it in the garage until you work out what problem you have


What would cause your transmission to jerk when going from neutral to drive in my 200 Pontiac grand am?

Idle speed too high.


Where is the fuel filter in a 1999 Pontiac grand am se?

It is located to the rear of the fuel tank and behind the rear differential up high.


Why don't I have low beams on my Pontiac grand prix gtp but have high beams?

the low beam part of the bulb could be bad.