0
96 Ford ranger When applying the brakes the left turn signal comes on Left turn signal only works correctly when brakes are not in use?
Wiki User
∙ 16y ago
It sounds like the posative brake light wire is shorted out with the left turnsignal light wire. These are easily accesable in the trunk and also as a result eazily damaged. Locate the damaged wires and tape them up. Hope this helps.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Turn signal go solid when brakes is applied?
It could be a few things. It could be a bad ground on the light bulb (the bulb could be working but be corroded at the ground), a bad flasher unit, a bad turn signal switch, or a bad bulb.
What are turn signal indicators?
Turn signal indicators are lights. The flash to tell you, or indicate, that a turn signal is on, and which way the lights are flashing.
What is the function of a relay valve or splitter valve in an air brake system?
Relay valves are used to reduce the lag time when the brakes are applied, and when they are released. They are remote controlled air valves that respond to a con trol signal from the foot valve. They are usually mount ed on a frame rail close to the air chambers that they are to operate.
Where is the signal flasher located on a 2001 Kia Sephia?
The 2001 Kia signal flasher relay switch can be found beneath the drivers side dashboard. The signal flasher relay switch will be above the brake pedal.
Fuse good turn signal flasher unit good no signal or hazard lights?
The switch must be shot. What kind of vehicle is it?
1989 silverado left turn signal set applying brakes causes the left turn signal to dimm and the two right rear tail light bulbs to alternate brightly?
1989 silverado left turn signal set applying brakes causes the left turn signal to dim and the two right rear tail light bulbs to alternate brightly? Further problem occurs to same truck - in Park and brakes not applied -- if head lights are on turn signal flash slows right down almost to a stop and becomes very dim
1994 ford ranger turn signal switch?
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
Why does the left turn signal stop when you apply the brakes on a 1996 Ford Ranger?
Most likely you have a grounding problem in the left tail-light. See if the wire is disconnected, broken or if the grond wire connection is corroded where it connects to the body.
Why do Turn signal works but not brake lights your jeep?
Check the fuses for your brakes.
When your lights are on and you hite the brakes your left turn signal goes faster?
if your signal is faster than normal then you need a new bulb
Where is the turn signal hazard flasher located on a 2004 ford ranger truck?
The 2004 Ford Ranger pickup truck signal hazard flasher unit can be found beneath the drivers side dashboard. The signal hazard flasher unit will be above the brake pedal.
What is wrong If Signals work great until applying brakes in which case the dash indicators both blink as do all signal lamps rear fixtures are Class A using common signal brake filament?
What your describing sounds like an electrical ground problem. Make certain that the ground wire connects to the vehicle chassis and that the connection hasn't rusted.
What number is the turn signal fuse for a 1993 ford ranger supercab?
13
How to Identify signal wire on oxygen sensor for 1988 ford ranger 2.9l?
you can breath
Why would your turn signal lights only come on when you are pushing on the brakes?
i think your car is broken
Why do my 2003 ranger blinkers do not blink lights come on but do not blink?
turn signal relay is bad
Ford Ranger turn signal?
WHAT IS THE QUESTION? yes ford rangers have turn signals LOL
