answersLogoWhite

0


Best Answer

16mm

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 97 Honda cr250 carb float height?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the Float adjustment for 087A keihin carb for a 550 Honda motorcycle?

22mm is the float height for this carb


Where can you find a carb for a 1995 Honda cr250 for cheap?

E bay , new carbs cost about 50-70 dollars.


Why does your Mikuni Carb leak fuel from the overflow at high RPM's?

float height


Where is the carb drain screw on a cb250 Honda?

on the left(shifter side) of the carb, on the float bowl. small standard screw (flat head)


1978 Honda cx500 stored for the winter started yesterday and major gas leak through drain hose.?

Adjust the float in the bottom of the carb.It is a trial and error adjustment, bend the tab for the pin little by little.do not mess with float height if was running ok before storing up sticky float or muck in carb are causesCheck to see if the screw on bottom of carb to drain the carb was left open from last fall's winterizing!


What causes carburetor overflow tube to leak gas on 03 Honda rancher?

your float is stuck in the carburetor. Clean it with carb cleaner.


You are having problemes with your Honda aero carb fuel just runs out tube at bottom of carb how do you adjust float or is it something else?

The float is stuck in the OPEN position. Try sharply rapping on the float bowl several times with a non -metallic object. Screwdriver handles work great for this. I seriously doubt that the float went out of adjustment all by itself. Worst case scenario - take the float bowl off and spray carb cleaner around inside.


What causes gas to get in engine oil on Honda rancher?

Float needle sticks in carb and allows excess fuel to seep past rings into oil.


Honda 200s carb adjustment?

Factory carb settings for a 84 Honda 200s


How do you fix a leaking carburetor on a scooter?

Well your floats are probably stuck, so take off the carb and remove the float bowl or round thing on the bottom of the carb. Next there is a little pin that holds the floats that you are gonna want to remove then take the float needle out and use a Q-tip to clean it out and reassemble the carb. If it still leaks then you need to adjust the float height by bending the little tab on the floats until it stops leaking.


What would cause a carburetor on a 1998 Honda cr 250 to leak gasoline out of the overflow hose?

Usually any fuel leaking out of the carb like that would be an indication of a sticking or defective needle/seat and or float mechanismn. Clean thoroughly with carb cleaner and or rreplace needle/seat/float and bowl gasket.


Why is float bowl drain hose leaking?

sounds like you have a float that is stuck. when the float stcks down it allows more gas into the carb. you may need to pull the carb to clean the float needle and seat.