0
97 Saturn Sl2 What would cause a clunking noise in the front end on the drivers side when you reverse with the wheels turned to the right. Could it be an axle shaft.?
Wiki User
∙ 17y ago
The bearing at the wheel end of the shaft is probably crackede or broken. Replace it.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What is the clunking noise when you turn a corner in a 1994 Jeep Grand Cherokee Limited?
Sounds like your ball joints are shot. Could also be your axles. I had the same noise, clunking when i turned and it turned out to be my axles. Check the boots to see if they are ripped.
What is the rumbling clunking noise when the steering wheel is turned corners turned in a Renault clio 1995?
Most likely CV joints.
Clunking in front wheel of Chevy Trailblazer?
Mine had a clicking noise and it turned out to be the front passanger side axle assembly.
Could Saturn or Jupiter have turned into suns?
no - they're planets. Suns are stars.
Can a reverse air conditioning lose freon when the heat is turned on?
Does a tire with a slow leak lose air when you are driving in reverse?
96 Saturn belt slip when defrost turned on?
when the defroster is turned on, it activates the a/c compressor. the clutch may be locking up on the compressor.
How old DID you have to be in 1970 to get drivers license and permit?
That varies from country to country and from state to state. In most U.S. states in 1970, you could get a drivers license when you turned 18, or when you turned 16 if your parents agreed to be responsible for you until you turned 18.
What causes a loud clunking noise that occurs only when truck is in FWD and wheels turned sharply for a 1992 Chevrolet FWD truck?
you need to check the front axel u-joints NEUTZ
What is the top speed of a 2001 Saturn SL2?
I topped out around 110-115 and my car turned off haha
Does nick have his drivers permit?
Yes, he got it recently. He turned 16 on September 16, 2008
What would cause heavy clunking sounds from under rear of car when moving?
Just had that problem on the rear of a Lexus ES300 and it turned out that both rear sway bar frame bushings were worn out. After replacement the car sounds quiet.
Can a used snooker cloth be turned over and used again?
No. There is a proper side and a reverse side to the cloth.
