0
Check your starter wires. I crossed one of my wires on my old S-10 when I stuck a starter on it and it just kept turning over as I touched the wire to it. A wire is corroded or touching somewhere near it. At least that's what it was for me. Hope this helps and I'm not too late
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What do you do if you pull the key out of the ignition but the car still keeps running?
Disconnect the battery.
Laptop keeps on turning off when you open it.?
Battery could possibly be burnt out.
What has happened to my iPod It keeps turning off and won't turn back on again?
Have you checked your battery?
Why does 1995 Toyota Tacoma pulley keeps coming loose why Tacoma?
i have a 1998 Toyota tacoma pickup the pulley is loose on it does it free float or what
Where is the PCV valve located on a 1998 Lexus gs 400?
my 98 gs keeps turning off it has new alterneider, and battery
When replacing a starter solenoid in a 1989 mercury topaz what keeps your car from starting?
Not quite sure what you are asking, but if you are changing the solenoid, then disconnect the battery first.
When was The World Keeps Turning created?
The World Keeps Turning was created in 1992-07.
Your 2002 Taurus alarm keeps going off?
There are a couple steps you can take when your 2002 Taurus alarm keeps going off. You can either disconnect the battery or bring your car to a professional to reset the computer in the car.
How do you remove a battery from a 2002 Chevy Astro van?
open the hood then undo the positive red battery cable then undo the negative cable and you will need a 10mm socket wrench to loosen the safety clamp hold plate that keeps the battery from turning over do this and your done
What are the ratings and certificates for Mocca Life Keeps on Turning - 2011?
Mocca Life Keeps on Turning - 2011 is rated/received certificates of: Singapore:PG
What do you do when headlight keeps turning off?
You fix it
How do you remove the battery from a BMW 550i?
The battery is in the trunk, same side as the gas cover door. First, you need to remove the covers (twist the plastic retainers (2x) 1/4 turn) remove the bar that keeps the battery down (2 screws) disconnect the negative terminal (easy) on the positive terminal, lift the red cover out of the way, and disconnect one set of cables. then lift up the other part of the red cover and loosen the screw to remove from the positive terminal. loosen the (long) screw that holds the battery down, it is closest to you. disconnect the venting tubing, on the far side of the battery Lift up the battery, making sure that you're not pulling/tugging on any wires (i had to disconnect one cable connection, but i might not have been necessary. just be careful) put in your new battery, and repeat everything in reverse.
