0
With the hood up and facing the engine, look to the coolant reservoir, under it is a quick disconnect which houses the sensor. If you disconnect this you will see the radiator/over heat signal flashing on your dash board.. hope this helps.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is it important to have Temp coolant sensor does it matter on a 1989 honda accord?
the temperature sencer tell your fans to turn on when the coolant in your radiator gets to hot
What can make a 2000 Mercury Sable 3.0 dohc run lean?
the o2 sencer, temp. sencer, or the air temp sencer can. the o2 sencer, temp. sencer, or the air temp sencer can.
What could be the reasons for the coolant fan not working on a Honda Accord LX?
it is possible that the relay is bad and or the temp sencer is not working proply john paul
When was David Sencer born?
David Sencer was born in 1924.
When did David Sencer die?
David Sencer died in 2011.
What does tha crank sencer do?
What will be the sign when the crank sencer is not working?
What does Code P1166 on a Kia Optima mean?
It means your heated oxegen sencer bank one is bad that is thr front of the motor on the exhaust by the radiator top one
How do you install the crankshaft position sensor on a 1987 Buick Grand National?
rotate the engine until you have the gape on the interupter ring over the crank sencer. remove the crank sencer assembley that bolts to the block with the sencer attached. ( do not take the 5/16 bolt loose that holds the sencer.(unplug the wires to the sencer first. once yu have remover the sencer assembley from the block you can tell how to set up the new sencer. mark the sencer with a knife or paint pen so you can see how to set up new sencer. Now you are readty to remove the 5/16 bolt. back the bolt out and remove the sencer for the bracket. pay attention where you marked the old sencer. Mark the new sencer in the same location and place it back in the bracket,( Be sure to alighn the sencer exactly as the old on. Then tighten the 5/16 bolt back..DO NOT over tighten this bolt. now reinstall assenbley back onto the block. Be sure not to break the window of the new sencer as you reinstall. it will be a tight fit but it will go. Take a flywheel tool and turn engine BY HAND to make sure you have properly set up your sencer. As long as it does not hit it will be good. if it does hit, back off the 5/16 bolt and move the sencer until it does not make contact with tha interupter ring on the crank shaft. plug your wires back into the sencer. start engine an have fun.. Hope this help.
Where is the 1999 Acura Integra cooling fan sencer?
1999 fan sencer for acura integra
Where can you get the cheapest co2 sencer?
Try Amazon.com
Where is the heat sencer located on the engine?
on the top
7 How do the automatic doors at a supermarket know when to open and close?
The doors have a black thing at the top of them. Inside that thing is a sencer and when you walk in to the sencer the doors open.
