three steps 65
Torque specs can be found in the Haynes Auto Manual.
call the dealership talk nice. they will give you the answer. basics. 1. this car motor uses stretch- bolts. 2. torque settings are likely something close to torque to 55foot LBS... and turn 90 degrees PS. this is usually done in three tightening stages. because this is an aluminum head. the bolts are the bounce type. good luck.
You risk breaking the bolts, or crushing the gasket to the point where it will not seal.
The 1999 Dodge 3.3 liter cylinder head bolts should be torqued at 160 pounds psi. The head bolts should be torqued in 40 pound intervals.
How much to repair a head gasket for a 2002 dodge stratus
The head bolt torque for the Dodge 6 cylinder and V-8 engines is 50 ft. lbs. torque. If it is a diesel engine, the torque is 90.4 ft. lbs. Tighten the bolts by working from the center out, and alternating side to side. This prevents warping of the head.
Torque wrench,90 ft.pounds
torque for 2c engine cylinder head bolts
torque setting for cylinder head bolts for a skoda felicia
45 ft/lb, 65 ft/lb, 65 ft/lb plus 1/4 turn with new head bolts.
Torque for 292 head bolts is 95 ft lbs
to what torque must the bolts on the head of a 2000 Hyundai accent be tightened?