answersLogoWhite

0


Best Answer

the length of the cord or cable from a busway plug-in device to a suitable tension take-up support device shall not exceed 6 ft.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: A flexible cord connection is made directly to the load end terminals of a busway plug-in device. The maximum length of this cord to a tension take-up device is?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the maximum weight a flexible cord can support?

5kg


What is the condition for maximum current that can be drawn from a cell?

The maximum current that a cell can deliver flows when the resistance between the terminals of the cell is zero. This situation occurs when the terminals are connected by a conductor with very low resistance, such as a thick wire or a wrench. But not for long.


Maximum client for odbc connection?

Maximum client is the maximum number of requests that can be served by webserver at a time.


What is the maximum number of IDs available in a fiber Channel connection?

16


Maximum connecton speed of an 802.11g wireless connection?

11 mbps


Give three examples of protocol parameters that might be negotiated when a connection is setup?

The protocol parameters that may be negotiated during the setup of a connection could be maximum packet size, maximum transmission/reception speed, and quality of service standards.


Maximum number of virtual terminal in cisco switch?

The amount of virtual terminals available is dependent on the switch itself. However, the average number is 15.


When is acceleration greatest in SHM?

At the point of maximum displacement, since the two are directly proportional.


What is the maximum number of feet that a safety net can be placed directly below the working surface?

The maximum number of feet that a safety net can be placed directly below the working surface is 30 feet. However, closer is better and the net should be closer if possible.


Which color light has maximum energy?

The amount of energy is directly proportional to the frequency of the light. Since violet has the greatest frequency, it also has the maximum energy and red has the least.


What value of current in a 1W - 20V zener diode must be limited to a maximum?

ANSWER A reverse biased 20 V zener clamps the voltage across its terminals to 20 V. Since 50 mA x 20 V = 1 W, the current through the diode should be limited to a maximum of 50 mA. In practice, this current maximum would be derated for reliability reasons.


In Properties and Modem Configuration of Connect Using it says my Maximum Speed in bps is 115200 but a dropdown menu gives higher and lower numbers to select what are these for?

115200bps is the maximum speed and i'd leave it there. determines your connection boot speed