The blower motor resistor on a 1994 Acura Legend is typically located underneath the dashboard on the passenger side, near the blower motor itself. You may need to remove the lower dash panel to access it. It is mounted to the HVAC housing and is connected to the blower motor wiring harness. Always consult your vehicle's service manual for precise instructions and safety guidelines.
it's the blower motor
i had a 1990 acura legend my blower motor was located under the passenger side dash board
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
To remove the blower motor from a 1995 Acura Legend, first disconnect the negative battery cable to ensure safety. Then, remove the passenger side lower dashboard panel and any necessary trim pieces to access the blower motor housing. Disconnect the electrical connector and unbolt the blower motor from its housing, then carefully pull it out. Reverse the steps to install the new blower motor.
Resistor is a separate unit from the blower motor
Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.
The blower motor resistor has failed.The blower motor resistor has failed.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.