Anything that's considered DOT 3 or DOT 4. It'll show on the bottle whether or not it's DOT 3...Just go to your local auto parts store (Pep Boys, Advanced Auto Parts, Discount Auto Parts, Walmart, etc.) and they should have them there.
how do you add transmission fluid on 98 acura cl 3.0
The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.
Usually at the upper end of the brake pedal under dash area
Check the level of brake fluid in master cylinder - if low could be indicator that brake pads are worn and need replacement or leak in system and needs attention. Check to make sure that parking brake is fully released
To replace the rear corner lights on a 1998 Acura CL open the trunk. Find the brake light housing and disconnect the bulb. Install the new bulb.
Under the dashboard above the brake pedal.
Any type of SAE certified transmission fluid can be used in the 1997 Acura. The transmission should never be overfilled.
this is normal i have an 01 accord and 99 tl both circulate the fluid.
Acura CL was created in 1997.
It is critical that you use only Honda ATF. Do not use any other fluid, no matter what anyone tells you. Your Acura will not shift properly with any other fluid and you it may be damaged. Purchase the fluid at your Honda/Acura dealer.
It's on the drivers side of the engine. The dipstick has a yellow loop handle.
Could be low on fluid Have fluid and filter changed - may be an inexpensive fix