Mazda 626

After installing a fuel filter in a 1997 Mazda 626 LX what is the procedure for starting the car if it cranks but sounds as if it is not getting fuel?

232425

Top Answer
User Avatar
Wiki User
Answered
2005-01-31 07:17:41
2005-01-31 07:17:41

Could the new fuel filter be installed backwards, therefore shutting off the fuel supply?

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I would suspect that if it is getting fuel and not starting it would be that it is not getting any spark. If you find that it is not getting spark you could check: Ignition module Crank position sensor Engine control module Associated wiring and connectors

if its cranking but not starting most likely fuel pump

If your Honda CRV cranks but won't turn over because the spark plugs are not getting spark, ensure the wires are connected. A loose spark plug wire can cause this issue.

it is easier to pedal with longer cranks because you have more leverage but it is not necessarily better to have really long cranks.

The window cranks are these pot-metal castings with plastic covers. If you peel the plastic cover back, you'll see the screwhole.

I would replace the ignetion module that is in the distributor.

Check for spark and fuel. You are not getting one of those.

Replace the engine coolant temp sensor.

check for spark at plugs,coil.check you are getting fuel check ignition condensor

A 2002 Jeep Grand Cherokee engine that cranks but is not starting and has no dash gauges is experiencing an electrical system failure. This can be a result of a faulty ignition switch or damaged wiring.

Have the intake air temp. sensor checked .Two wired plug on top of intake manifold. Check fuel pump pressure.

Check for codes(possible cam sensor), check fuel pressure bleed down(possible fuel pump).

do you mean it cranks, but will not start?

If the engine cranks & cranks & cranks before it starts even though it's warmed up already.

For some reason it is not getting EITHER fuel OR spark , so it cranks but doesn't start

No of cranks used in 6 cylinder engine

There are two main types of no-starting conditions. Cranks but won't start, and no cranks no start. For a no crank no start condition it is best to suspect a problem with the starter circuit. For a cranks but won't start you have to remember that an engine requires the things to run gas, air, and spark. So what type of condition do you have?

Cranks is the motor turning over, But cranks and won't start means either you no fuel or no spark or both.

This is a bad question. fix it. check fuses . there are sevearal fuses that will stop it from starting

No, it won't keep it from starting, however it may retard your timing and affect driveability.

The duration of Those Wonderful Movie Cranks is 1.5 hours.

Change plugs, check your ignition coil. an check your batt(it needs to be fully charged)

Pushing on the cranks puts tension on the chain, which rotates the rear wheel and pushes the bike forward.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.