hi... from what i can make out the 3 wires are part of an imobiliser which has 2 captive screws these have to be drilled out and imobilser removed to reveal just the one wire
One can set an injector for a 320 diesel marine engine by setting the timing and duration.
That completely depends on the type of injector needed and the application(engine)
You can disassemble an injector on Komatsu D21A-5 dozer diesel engine with the help of the official certified Service and Repair manual.
The 2006 Ford F2 50 diesel engine might have a bad fuel injector. The injector can cause the engine to not run properly, until the engine warms up.
in appropriate injector's, clocked injector nozzle's, injector pump diaphram ,(due to dirt fuel)
You can remove the injector, on your C 12 Caterpillar diesel engine, by removing the injector rail. Remove the retaining nut and the injector will come out.
No!
Due to the mechanical response of the injector
will need recoding
The torque specifications for an injector, on a Caterpillar see nine diesel engine, is seven pounds. Over torque in the injector can ruin it.
If you are referring to ignition timing, diesel ignition timing is primarily controlled by the injector timing. This is also why diesel engines run such high injector pressures. The timing is very carefully controlled by the vehicles computer.
because of in the diesel engine fuel injector is uses for ignite the charge & they are operated by fuel pump not to electricity and in the diesel engine there is no requirement of spark plug to genrate the spark