It varies at the part of the country you live in. Call a couple of local garages for estimates.
It takes approximately 0.8 hours to replace the charger. Ask around for hourly charges... most garages charge about $65 an hour, so it would come out to about $52 +the part. Ask at a local parts store how difficult it would be to do it yourself. It is usually "plug-and-play", I've done older cars often. The part is guaranteed, too! It is a great first job for learning, and will give you confidence, at least for older cars. Check with the store, and read the relevant page(s) in a Chilton Manual at your library.
Make sure the solonoid is bad first.. It is on top of the starter and the starter has to be removed to replace it.
how to replace a heater core in a 1997 Chevy blazer
How do you replace the starter on 2002 chevy avalanch
It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.
The starter solenoid is attached to the starter.
how do you replace seatbelt retractor on a 2000 chevy blazer
Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Where is the starter on a 2004 Chevy trailblazer.
where is the blower motor on a 2001 chevy blazer
how do you replace dome light in s10 chey blazer?
No, there is a starter solenoid located on the starter motor.
Starter solenoid? It is attached to the starter.
How do you replace a starter in a 1999 suburban
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
how do you replace the starter on a 2006 chevy hr
Look at the lower rear of engine
The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.
on a 2002 4 wh drive Blazer - disconnect the battery - lossen starter bolts ( 2 ) loosen and remove the Flywheel plate that the Starter is inserted into or you wont be able to pull the starter out - really tight space 2 bolts to remove this plate - plate has an opening that the starter goes into to engage the flywheel
It is attached to the starter. The positive battery cable runs directly to it.
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
Replacing a wheel bearing in your Chevrolet blazer will cost approximately $175 per bearing. You can save $125 by doing the work yourself.
The starter motor/solenoid on a 2000 Chevy S10 Blazer is on the lower passenger side of the engine block. If your trying to replace it, first, disconnect the negative battery terminal. Remove the differential carrier shield. Disconnect the bolted solenoid cables. Remove 2 vertical bolts securing the starter motor to the engine block. When reinstalling starter, tighten mounting bolts to 50 Nm/37 lb. ft.
Bottom of the motor, passenger side.
Passenger side bottom of engine.
With the right tools and knowledge, no.