Want this question answered?
Connect an LED, two AA batteries, and a resistor of around 100-150 ohms, all in series.If the LED doesn't light, then turn either the LED or the batteries around in the circuit.
Depends on how you add them. Added in series, the voltage will increase, maybe to the point of damaging the LED. If the LED survives, it will shine brighter. Added in parallell, the LED will shine the same, and will be able to shine longer before draining the batteries.
Only in "trace" amounts, if that. Lead is used primarily in wet cell (automobile) batteries.
The led glow when it is attached to the batteries.
Germany's desire to be dominant.
It will depend on what battery you need. I use rechargeable AAA and AA batteries for my lights. Bike computer batteries will vary depending on the type used.
Not very many flashlights use c batteries, but one example would be the 3C ProPolymer LED flashlight.It is Powered by 3 C alkaline batteries.
they have citric acid in them and it replaces sulphuric acid in batteries. :-)
The wand has a type of LED on the end and is powered by two AAA batteries, the LED brightens and dims, the batteries are stored inside the wand itself, so this makes it thicker than the normal wands.
Germany's desire to isolate france and britain's desire to remain dominant
Germany's desire to isolate France and britain's desire to remain dominant
It's probably only a 1.2V LED. It just depends if the batteries are connected in series or parallel.