The warning lights on a 1988 Toyota Celica will usually mean that your engine is needing to be serviced. However, the warning lights can also mean that your brakes need to be serviced or repaired.
We have a 1988 Celica GTS and we just replaced our pipes...they were 2"....should be the same....
You cant just change the bulb, you have to change the whole headlamp.
23 in the city, 29 on the highway, and 25 combined(city and highway driving) You can find this information on www.fueleconomy.gov
Get a manual on your car to do the job right. In short, you have to pull the timing belt covers and timing belt. Get a manual.
take the tires off and old brakes off and put the new ones on. put the tires back on and drive!!
I have a 1988 Toyota Celica and I had to replace the entire exhaust and it was approx $800.Answeri have an 87 Toyota celica GT and i just took mine down to Marco muffler and they took out out ALL of the mufflers and replaced them with one glasspack (that i provided) and put 2 and a half inch pipe out the back. They wanted $80 and i talked them down to $50. Sounds pretty nice. Not like a rice rocket, but a lower growl.
Change a starter on a 1988 Toyota Cressida
how to do ignition timing on 1988 Toyota corolla fx
How do you change a fuel injector on a 1988 Toyota Camry
with the heated girth of your fat girlfriend
Wikipedia says less than 1300 verts
its on the driver's side of the engine compartment. You will have to remove the air intake box and tube to see it. If all else fails, follow the fuel line back from the fuel rail until you find it.
what is spark plug gap for a 1988 Toyota Camry? using a 5503 autolite.
You can find a 1988 Toyota carburetor diagram at most Toyota dealerships. The diagram can also be found in Toyota service manuals at your local library.
This vehicle does not have a rear wiper bladed listed in the aftermarket wiper blade catalogs which indicates the 1988 Toyota 4 Runner has a proprietary wiper arm and blade and you must go back to the dealer for a new wiper blade. At this time, universal blades do not fit.
torque specs on head gaskets 1988 toyota corolla 4A-F
The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.
Im thinking and the bottom left hand side of the engine bay. (Facing Car) I have a 1988 Celica ST, dont know if it differs from GT.
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
there is a fuse for them but check if u have spark and fuel pressure before u waste money and its not that.
No, its fuel injected engine