The warning lights on a 1988 Toyota Celica will usually mean that your engine is needing to be serviced. However, the warning lights can also mean that your brakes need to be serviced or repaired.
We have a 1988 Celica GTS and we just replaced our pipes...they were 2"....should be the same....
You cant just change the bulb, you have to change the whole headlamp.
I have a 1988 Toyota Celica and I had to replace the entire exhaust and it was approx $800.Answeri have an 87 Toyota celica GT and i just took mine down to Marco muffler and they took out out ALL of the mufflers and replaced them with one glasspack (that i provided) and put 2 and a half inch pipe out the back. They wanted $80 and i talked them down to $50. Sounds pretty nice. Not like a rice rocket, but a lower growl.
23 in the city, 29 on the highway, and 25 combined(city and highway driving) You can find this information on www.fueleconomy.gov
take the tires off and old brakes off and put the new ones on. put the tires back on and drive!!
it is in taylorville
thermostat is located on engine block. follow top water hose leading to engine. thermostat is located inside the water intake. remove hose. remove water intake(two bolts)housing. replace thermostat. .
buy a new turbo and replace it
How do you replace the water pump on a 1988 Cadillac Seville?
I just want to know when do i have to replace the water tank.
you just pull it out you just pull it out
Call up a locksmith and have a talk with him will direct you in the right direction.
They are not aftermarket, they just were not done at the Toyota factory. They are factory authorized conversions done in California. I believe the same company may have made GM's convertibles during the late 80's as well.
I'm dealing with the same problem on my station wagon Camry 1989. Pep boys say have to order thru Dealer
Change a starter on a 1988 Toyota Cressida
In order to replace the water pump on a 1988 Toyota Camry v4, first remove the front timing belt cover as well as the motor mount on the passenger's side of the vehicle. In order to remove the mount, the engine must be supported. Before removing the timing belt, mark the camshaft and crankshaft for guidance during replacement. Remove the water pump, and apply new gaskets to the new water pump with a sealant. Install the new pump, then the hardware that had been removed in order to access the pump.
how to do ignition timing on 1988 Toyota corolla fx
How do you change a fuel injector on a 1988 Toyota Camry
2 hours max....
oil can come from about any were, it could be coming from the rear main or the front you can ha gasket that you need to replace.
it depends on who does it.
with the heated girth of your fat girlfriend
depends on who does it...normal time bein 3-5 hours