the speakers are 8kOhm or 8000Ohm
You need to match the speaker with the amplifier. Better or worse is not the question. The question is dynamic range and the possibility of overloading the amplifier. If the amplifier is rated 4 ohms, use a 4 ohm speaker. Same for 8 ohms. Do not "mix and match".
Most power amplifiers will handle a load of 6 ohms. The spec you need to look at is the power handling of the speakers. If they are rated for 100 watts program power, then look for an amplifier rated for 100 watts RMS output. Any amplifier can be connected with adapter cables to the typical 1/8" output of your computer.
Yes, you can use 2 in series, IE daisy chain them to add up to 8 ohms.For stereo you would need 4 speakers not 2. mono, 2 not one.Most Amplifiers work OK driving to a lower impedance loads anyway so just hook them up. Very high power levels may overheat the amp but at normal volume it should be fine. Something important is added: There are no 8 ohm amplifiers! The amplifier will have an output impedance of around 0.04 ohms. In hi-fi we have always impedance bridging. Zout
Answer #1Yes. 4 ohm speakers, when driven to the same voltage level (same volume control setting), try to draw four times the power (watts) of an 8 ohm speaker. This can overload the amp and cause it to fail. Answer #2It's a myth. There is really no 8 Ohm amplifier on the market. And there never was. The amplifier will have an output impedance of around 0.04 ohms. In hi-fi we have always impedance bridging. Zout
This depends on the individual theatre, but can range anywhere from 3-8.
yes
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
The 6 ohm speakers will sound fine with the 8 ohm amplifier.
they are probably 4 ohm
yes
They are 6 ohm.
Yes
The ohm rating is 8 ohm on the rear speakers in a Pontiac Sunfire. They can be switched out, as long as the front and rear speakers match.?æ
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
You can, but its power output will be a bit higher than its 8 ohm rating.
Four 8 ohm speakers wired in parallel would give an effective 2 ohm load.
Yes, you can safely use a 4 ohm amp with one 8 ohm speaker, but you will not achieve full power. The 4 ohm amp is designed to supply a certain voltage into a 4 ohm speaker. Supplying that same voltage to an 8 ohm speaker will result in half the power, or -3dB. For maximum power, use a 4 ohm speaker, or two 8 ohm speakers in parallel.