0
the speakers are 8kOhm or 8000Ohm
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Is a 4 ohm subwoofer better then a 8 ohm subwoofer?
You need to match the speaker with the amplifier. Better or worse is not the question. The question is dynamic range and the possibility of overloading the amplifier. If the amplifier is rated 4 ohms, use a 4 ohm speaker. Same for 8 ohms. Do not "mix and match".
What power of amplifier do i need for 6 ohm speakers to connect them to my computer?
Most power amplifiers will handle a load of 6 ohms. The spec you need to look at is the power handling of the speakers. If they are rated for 100 watts program power, then look for an amplifier rated for 100 watts RMS output. Any amplifier can be connected with adapter cables to the typical 1/8" output of your computer.
Will 8 ohm speakers work with a 4 ohm amplifier?
Yes, you can use 2 in series, IE daisy chain them to add up to 8 ohms.For stereo you would need 4 speakers not 2. mono, 2 not one.Most Amplifiers work OK driving to a lower impedance loads anyway so just hook them up. Very high power levels may overheat the amp but at normal volume it should be fine. Something important is added: There are no 8 ohm amplifiers! The amplifier will have an output impedance of around 0.04 ohms. In hi-fi we have always impedance bridging. Zout
Can 4 ohm speakers cause an 8 ohm amp to fail?
Answer #1Yes. 4 ohm speakers, when driven to the same voltage level (same volume control setting), try to draw four times the power (watts) of an 8 ohm speaker. This can overload the amp and cause it to fail. Answer #2It's a myth. There is really no 8 Ohm amplifier on the market. And there never was. The amplifier will have an output impedance of around 0.04 ohms. In hi-fi we have always impedance bridging. Zout
How many speakers are in an imax theater?
This depends on the individual theatre, but can range anywhere from 3-8.
Are logitech Z-680 satillite speakers 8 ohm?
yes
How do you wire two 8 ohm speakers and keep a 8 ohm load?
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
Will 6 ohm speakers sound quality be affected with using an 8 ohm sound system?
The 6 ohm speakers will sound fine with the 8 ohm amplifier.
Are Bose car speakers 8 ohm?
they are probably 4 ohm
Can you use 4 ohm speakers on a 8 ohm system?
yes
Are Baby Advent II speakers 8 ohm?
They are 6 ohm.
Can you make four 8 ohm speakers into an 4 ohm load?
Yes
What is the ohm rating of rear speakers in a Pontiac sunfire?
The ohm rating is 8 ohm on the rear speakers in a Pontiac Sunfire. They can be switched out, as long as the front and rear speakers match.?æ
How do you use 16 ohm monitor speakers with an 8 ohm powered mixer?
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
How do you connect 2 6 ohm speakers to an 8 ohm amplifier?
You can, but its power output will be a bit higher than its 8 ohm rating.
What ohm should the speaker be if i want to achieve a 2 ohm load from 4 speakers?
Four 8 ohm speakers wired in parallel would give an effective 2 ohm load.
Can you run 4ohm resistor to make 4 ohms speakers 2 ohm?
Yes, you can safely use a 4 ohm amp with one 8 ohm speaker, but you will not achieve full power. The 4 ohm amp is designed to supply a certain voltage into a 4 ohm speaker. Supplying that same voltage to an 8 ohm speaker will result in half the power, or -3dB. For maximum power, use a 4 ohm speaker, or two 8 ohm speakers in parallel.
