Hyundai
Hyundai Accent

Are rotars for a 1998 Hyundai Accent pressed on?

252627

Top Answer
User Avatar
Wiki User
Answered
2005-09-25 01:03:01
2005-09-25 01:03:01

Yes they are; and they are a pain to remove.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Change front brake rotors on a 1998 Hyundai Accent?

The thermostat in a 1998 Hyundai Accent is located on the engine block. The thermostat can be found by following the upper radiator hose to the thermostat housing.

http://www.racepages.com/products/?Ntt=Hyundai+Accent+Starter&N=4294963578

The engine relay on my 2001 Hyundai Accent 1.6L is under the dash on the driver's side.

Click on the link to your right for the answer.

its on the back of the engine under the intake manifold

They are absolutly the same, you should have no problem at alla making the swap.

Try the original not worth upgrading

I had the same problem and it turned out to be the fuel purge censor

Get a manual on your car and do the job right the first time.

iT SHOULD BE ON AN AUTOMATIC TENSINOR DEVICE . NO ADJUSTMENT NEEDED.

Under bonnet in fuse box think labelled on cover

I have a 1998 Hyundai Elantra and had the rotors replaced, you will have to have a shop to do it because they have to be pressed off and then back on again with a specialized machine or tool. Of course unless you have that tool you can do it yourself. Good luck.

It is located under the rear seat. To access you must first remove the cover.

To replace the turn signal flasher in a 1998 Hyundai Accent, locate the flasher on the driver's side just above the brake pedal mount. The flasher is a plug-in device with three prongs. Unplug the old plug and plug in the new plug.

Trouble code P1624 means: Cooling Fan Relay Circuit Malfunction, Low Circuit

i have tried napa, advanced auto parts, auto zone, battery warehouse, noone had a battery for my 2007 Hyundai accent but CARQUEST did have it and said it is a newer and rare battery at this time ....1/4/2010

About $12 a piece (accents have four engine mounts) plus labor.

Its right in the back by the bumper in my 1998. You will see 2 hoses come of the filler hose that go right to it.

If you have had any luck since you posted would you please help me with same problem

u loosen up the pullie and replace it and put it back on its place (Quite articulate and complete. Must be an engineer)

the brake rotars are out of round or warped.have them machined


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.