The brake light bulbs are standard 1157. Any auto parts store will have them.
The brake lights on a 2001 BMW 525i are replaced by removing the retaining screws, pulling the light assembly from the vehicle, and disconnecting the bulb. A new bulb is then put in place and reassembled.
If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.
take out the old one and put in the new one
I have a 1994 325i and I had the same problem. I went into the trunk and replace the light bulb for $5.55 and that was all it took. One blown bulb caused the same effect in my BMW, Good luck
how do you reset brake warning light 0n 745li bmw
To replace the brake light first you need to remove the lens housing from the car. Next pull the entire bulb assembly, or housing, out of its hole. Remove the bad bulb, replace with the good bulb and place lens housing back into position. Secure the housing with the screws.
No vehicle year was given, so in general... BMW 525 brake light bulb lamp replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
how can i reset rear brake pad warning light on 2006 bmw 525i
My o/s parking lamp will not light, but, the indicator light is on instead, where do i change the bulb and how do i do this? BMW x5 2003
BMW servise
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.