Want this question answered?
There isn't a whole lot of extra room around the serpentine tensioner pulley so here is what I do... I put a box end wrench on the tensioner pulley nut. Then I push on the opposite end of the wrench with a long piece of wood... something thin enough to fit in the space you do have. I think I use a board that is about a half inch wide/thick. It helps if you have someone else remove the belt when you push on the wrench end. Gary from Princeton, MN
31-33
The 2008 Dodge Avenger has a drag coefficient of .33 Cd.
The Dodge Dancing Party - 1955 Do You Remember 19-33 was released on: USA: 27 April 1974
The 2009 Dodge Grand-Caravan has a drag coefficient of .33 Cd.
The 2010 Dodge Grand-Caravan has a drag coefficient of .33 Cd.
i just did a timing belt change on 1991 crx. according to my manual the tensioner bolt should be 33 foot pound or about 400 inch-lbs torque.make sure you use a six pointed 14mm socketso you won't round out the bolt head. since your a/c mount bolts are stationary they should be tightened about two hundred inch pound; your a/c belt should have 1/8 to 1/4 inch detent on the longest part of the belt and then tighten the nut on the pulley then tighten the adjustment screw. hope this help
The Life and Legend of Wyatt Earp - 1955 Dodge Is Civilized 4-33 was released on: USA: 28 April 1959
33 is ac clutch circuit. 55 is end of message/no more codes.
33
33/12.50
yes you can, I have a friend that has 33's stock height.