For mark1 Yaris
Unclip the bottom grill and remove. Push hand up to the lock and feel for the cable coming into the lock from drivers side. Move fingers along the cable until you reach the lock, then next you will feel the inner cable and where it is attached to its lever. Move that lever toward the drivers side and the lock will be released.
If you want to get the bonnet open when the catch has broken and the is no cable to get hold of the Renault Grand Espace; use the screwdriver to PUSH the catch from right to left.
pull the corde from near your pedals
Got the same problem. Anyone got the answer
well u need to find the broken end of the cable that's still attached to the bonnet release then u need to pull the wire that is INSIDE the black insulation easy enough with a pair of pliers or vice grips but i suggest u fit a need a cable to save hassle in the future
It will cost you a few hunderd quid to get this sorted by renault... or get some handy person to get the bonnet open, and using a cable tie connected to the passenger side bonnet release, connect said cable tie, and let the end poke out from the bonnet. This then becomes your new bonnet release. Any eagle eyed person with the knowledge will be able to open your bonnet from the outside. So do be wary of this solution. But it only costs a few pence for a cable tie vs a few hunderd quid from reno.
remove the left hand headlight it just pulls out and pull the cable from there if you still got some attached ok
You can do this buy removing the plastic front radiator grill. You need to remove indicator lights, then the middle screw, then with a small flat screw driver release the plastic clips just underneath the bonnet. Then put your hand behind the bonnet catch and pull the broken cable or the latch and it will open. Good luck
The latch is broken, not the cable. You can still get to the cable where it is attached to the latch in the foot-well of the car. Grab the cable with a small vice-grip (or similar) and pull. Note that it is very unlikely the cable will break -the latch typically breaks before the cable since the latch is made from plastic and the cable from steel wire.
call a mechanic
check speedsensor mounted on transmission follow the cable will lead to the sensor
Hi climb under the front of the car with a pair of pliers, reach up and pull the release.
The bonnet catch is in the foot well on the passenger side near the door but high up. Pull it to release the catch then put your fingers between the gap of the slightly open bonnet lid in the middle. You will find a small plate that needs to pushed up ton release the lid.