0
Brake lights on a 1995 Chevy blazer will not work the fuse and the sensor on the break peddle is good can you tell you what else could be causing the brake lights not to work?
Wiki User
∙ 14y ago
I have to assume that the "...sensor on the brake peddle..." is the BRAKE LIGHT SWITCH. If that is the case, AND if is checks out, as you imply, as good [or functioning] then I suspect that it may not be adjusted properly, so that the travel of the brake pedal is insufficient to allow the switch plunger enough travel to close the switch. Usually, the brake light switch is mounted such that by loosening a locknut, and screwing the switch in or out will allow adequate clearance to function.j3h. check the multifunction switch. they go bad on almost all GM cars and trucks. the turn signal uses the same bulb and wire as the brakes. if the switch is creating an open circut than the breaklights will not work
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Were is the iat sensor on a 97 blazer?
iat sensor on a 97 blazer and what does it do
What is a crank sensor for a 1995 blazer?
A 1995 blazer does not have a crank sensor. SORRY
Location of the MAP sensor on a 1991 Chevy Blazer?
where the map sensor on 98 blazer?
Where is the crank position sensor for a 95 blazer?
Where is the crank position sensor hole on a 2003 Blazer
Where is the speed sensor on a 2002 blazer?
The 2002 Chevrolet blazer speed sensor is located on the side of the transmission. The speed sensor will be on the right hand side of the transmission.
Which oxygen sensor should you change on your 1999 Chevy blazer back firing problems?
If it had a bad O2 sensor the "check engine" would be illuminated and a code would be set indicating which sensor is at fault. You probably have other problems causing that backfire to occur.
Where are the oxygen sensors located on a 1996 blazer where is sensor 3 bank one?
I have a code DTC P0154.Bank 2 Sensor 1 no activity.Which sensor is this on my 96 Blazer?
Where is the IAT sensor on a 93 Chevy s10 blazer?
The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.
Does a 1994 Chevy Blazer have an IAT sensor?
NO.
Does a 95 Chevy Blazer have a crankshaft sensor?
That year did not use a crank sensor.
1996 Chevy blazer where is bank 1 Sensor 2?
The bank 1 sensor 2 on a 1996 Chevy Blazer is mounted in the exhaust. Sensor two is just behind the catalytic converter.
2002 Chevy Blazer Where is the O2 sensor for bank 2 sensor 1?
pass.side at exe manifold Bank 1 is where cylender 1 is. Bank 2 is on the other side of which is on the passenger side of the blazer. Oxygen sensor 1 is the first sensor closer to the front of the blazer. Sensor 2 would be past the catalytic converter on the same side.
